32 lines
1.3 KiB
Plaintext
32 lines
1.3 KiB
Plaintext
|
|
Known bugs
|
|
|
|
Revision Current (no date yet)
|
|
------------------------------
|
|
|
|
|
|
Revision 2022-06-07
|
|
-------------------
|
|
- The LEDs for all bidirectional signals are activated only by pullups, which may lead
|
|
to low brightness and a signal voltage level that is below the desired 5V.
|
|
Workaround: Solder the LEDs in reverse and connect them to 5V instead of GND, as the
|
|
signal LOW state can sink more current. Will be fixed upon redesign/cleanup.
|
|
|
|
- ESP32 (azdelivery) has a wrong symbol where the "CMD" pin is labelled as GND, which
|
|
resulted in a short to GND on this pin.
|
|
Workaround: Remove the contacts from the pinheader that connects the PCB to the ESP.
|
|
Will be fixed upon redesign/cleanup.
|
|
|
|
- ESP32 GPIO12 is not supposed to be pulled up HIGH during boot (the pin doubles as a
|
|
bootstrapping pin, and will result in a boot loop if set to HIGH)
|
|
Workaround: Cut trace at the GPIO12 pin, connect the signal to GPIO13
|
|
Will be fixed upon redesign/cleanup.
|
|
|
|
- The ESP isn't programmable when inserted into the socket on the PCB. More and more
|
|
bootstrapping issues. In the end, the following remapping was necessary in total:
|
|
Signal Old New
|
|
ESP_D0 GPIO12 GPIO13 ok
|
|
ESP_D5 GPIO5 GPIO18 ok
|
|
ESP_STROBE GPIO15 GPIO19 ok
|
|
ESP_AUTOFD GPIO2 -
|
|
ESP_PAPER_EMPTY GPIO19 - |