37 lines
1.6 KiB
Plaintext
37 lines
1.6 KiB
Plaintext
Known bugs
|
|
|
|
Revision Current (no date yet)
|
|
------------------------------
|
|
|
|
|
|
Revision 2022-06-07
|
|
-------------------
|
|
- The PCF8574 is not suitable for our needs, as it can't source enough current
|
|
(300 µA max). Also it has a too-high leakage current, so that the relays are
|
|
switched on permanently, when the pins are in input state.
|
|
Workaround: Replace the part with the pin compatible PCA9554D
|
|
Will be fixed upon redesign/cleanup.
|
|
|
|
- The DMP3098 transistor is integrated backwards (swapped Source/Drain)
|
|
Workaround: Remove Q2 and the resistors, replace Q1 with a
|
|
suitable N-channel part like AO3422
|
|
Will be fixed upon redesign/cleanup.
|
|
|
|
- The pulldown resistor for the TCS signal bus has a too small footprint for the
|
|
current it has to withstand, and the needed value isn't determined properly yet.
|
|
Workaround: Solder a 1x2 female header on the pcb pads of Q1 (or the nearby
|
|
desoldered resistor) and the tcs signal, for providing a swappable method (wired
|
|
resistor).
|
|
Will be fixed upon redesign/cleanup, utilising a 1x2 2.54mm tht footprint and a
|
|
1206 resistor footprint in parallel
|
|
|
|
- ESP32 (azdelivery) has a wrong symbol where the "CMD" pin is labelled as GND, which
|
|
resulted in a short to GND on this pin.
|
|
Workaround: Remove the contacts from the pinheader that connects the PCB to the ESP.
|
|
Will be fixed upon redesign/cleanup.
|
|
|
|
- ESP32 GPIO12 is not supposed to be pulled up HIGH during boot (the pin doubles as a
|
|
bootstrapping pin, and will result in a boot loop if set to HIGH)
|
|
Workaround: Cut trace at the GPIO12 pin, connect the signal to GPIO13
|
|
Will be fixed upon redesign/cleanup.
|